Sending Data To The Host Computer; Charging; Led Indicators - Motorola MT2070 User Manual

Sending Data to the Host Computer

MT2000 Series include Ethernet cradle drivers that initiate automatically when you place the device in a properly
connected four slot Ethernet cradle. The cradle receives data from the device and transmits it to the host computer
via the Ethernet cable.
Prior to inserting the device in the cradle, it is recommended that you turn off the device's wi-fi radio to avoid
interference. To turn off the radio, go to the Home screen on the device and select Config > Wireless Companion >
Disable Radio.

Charging

To charge the battery in the device and/or a spare battery, ensure the correct power supply is connected then place
the device/battery in the cradle (see
on the device and in the cradle's spare battery section, start flashing green. A complete charge of a fully
discharged battery can take up to four hours.

LED Indicators

Device LED Indicators
Table 13-4
LED
Off No power applied to device (battery discharged or removed); device is in low power and ready to
scan; or, battery is fully charged and device is ready to scan.
Note: The default state of the LED is off when the battery is fully charged. By modifying the
BatteryLED.reg file under the \Platform directory on the device, you have the option to enable a solid
green LED on a fully charged battery. For detailed information, refer to the MT2070/MT2090
Integrator Guide, p/n 72E-117858-xx.
Green Flash Device is charging.
Red Flash Charging problem or data transmission problem.
Cradle LED Indicators
Table 13-5
LED
Solid Blue (Cradle Power LED)
Ethernet Activity LEDs
(Ethernet cradles only)
Inserting Batteries on page
Cradle is powered.
Speed LED (100/10) - Primary Port Connection
The cradle's green Speed LED lights to indicate that the transfer rate is 100 Mbps. When it
is not lit it indicates that the transfer rate is 10Mbps.
Link LED ( ) - Primary Port Connection
The cradle's amber Link LED blinks to indicate activity, or stays lit to indicate that a link is
established. When it is not lit it indicates there is no link.
13-8). Charging begins when the LED indicators,
Indication
Indication
Accessories 13 - 7