Pairing Methods; Unpairing; Disable - Motorola MT2070 User Manual

4 - 22 MT2070/MT2090 User Guide

Pairing Methods

There are two pairing methods. The default method allows the device and cradle to pair (connect) when the pairing
bar code on the cradle is scanned. A second method pairs the device and cradle when the device is inserted in the
cradle. To enable this feature, scan Enable Pair On Contacts below. With this feature enabled it is not necessary
to scan the pairing bar code on the cradle. If the pairing is successful, a low/high connection beep sequence
sounds a few seconds after the device is placed in the cradle. See Wireless Beeper Definitions on page 4-3 for
other beep sequences.
To enable or disable pairing on contacts, scan the appropriate bar code below.
Enable Pair On Contacts
*Disable Pair on Contacts

Unpairing

Unpair the device from the cradle or PC/host to make the cradle available for pairing with another device. Scan the
bar code below to disconnect the device from its cradle/PC host.
An unpairing bar code is also included in the MT2070/MT2090 Quick Start Guide.
Unpairing