Timeout Between Decodes, Same Symbol
Parameter # 89h
Use this option in presentation mode to prevent the beeper from continuously beeping when a symbol is left in the
device's field of view. It is programmable in 0.1 second increments from 0.0 to 9.9 seconds. The default interval is
0.5 seconds.
To select the timeout between decodes for the same symbol, scan the bar code below, then scan two numeric bar
codes from
Appendix D, Numeric Bar Codes
Hand-Held Decode Aiming Pattern
Parameter # F0h, 32h
This parameter only applies in Decode Mode. Select Enable Hand-Held Decode Aiming Pattern to project the
aiming pattern during 1D bar code capture; Disable Hand-Held Decode Aiming Pattern to turn the aiming pattern
off.
NOTE With
Picklist Mode on page 5-16
Aiming Pattern is disabled.
*
Enable Hand-Held Decode Aiming Pattern
(02h)
User Preferences & Miscellaneous Scanner Options 5 - 17
that correspond to the desired interval, in 0.1 second increments.
Timeout Between Decodes, Same Symbol
enabled, the decode aiming pattern flashes even when the Decode
Disable Hand-Held Decode Aiming Pattern
(00h)