Scanning In Single-Line Mode - Motorola Symbol LS9208 Product Reference Manual

2 - 2 Symbol LS9208/LS9208i Product Reference Guide

Scanning in Single-Line Mode

Install and program the scanner. See each host chapter and
Symbologies, Chapter 12, Miscellaneous Scanner
programming instructions. For assistance, contact your local supplier or Motorola Enterprise Mobility Support. See
page xi for contact information.
Ensure all connections are secure. See the host chapter for your host.
1.
Pick up the scanner. Press and then release the trigger. A single scan line displays.
2.
Scanning in Hand-Held Mode
Figure 2-2
Ensure the scan line crosses every bar and space of the symbol.
3.
RIGHT
012345
Press and hold the trigger until either:
4.
The scanner reads the bar code. The scanner beeps, the LED flashes, and the laser turns off.
a.
The scanner does not read the bar code and the laser turns off.
b.
Release the trigger. The aim scan line reappears. To read another bar code in single-line mode, repeat steps 2,
5.
3, and 4. Repeat this step as often as required.
After a programmable time period, the omni-directional scan pattern displays, indicating the scanner is ready to
read bar codes without use of the trigger.
For beeper definitions, see
Options, and
WRONG
012345
Table 2-1.
Chapter 4, User Preferences,
Chapter 13, Advanced Data Formatting
Chapter 11,
for