Usb Parameter Defaults - Motorola MT2070 User Manual

To set up the device:
NOTE Interface cables vary depending on configuration. The connectors illustrated in
only. The connectors may be different than those illustrated, but the steps to connect the device are the
same.
Connect the modular connector of the USB interface cable to the host interface port on the cradle or device.
1.
Plug the series A connector in the USB host or hub, or plug the Plus Power connector in an available port of
2.
the IBM SurePOS terminal.
Select the USB device type by scanning the appropriate bar code from
3.
On first installation when using Windows, the software prompts to select or install the Human Interface Device
4.
driver. To install this driver, provided by Windows, click Next through all the choices and click Finished on the
last choice. The device powers up during this installation.
To modify any other parameter options, scan the appropriate bar codes in this chapter.
5.
If problems occur with the system, see

USB Parameter Defaults

Table 9-1 lists the defaults for USB host parameters. To change any option, scan the appropriate bar code(s)
provided in the Parameter Descriptions section beginning on page 9-3.
NOTE See
miscellaneous default parameters.
USB Interface Parameter Defaults
Table 9-1
USB Host Parameters
USB Device Type
CDC COM Port Emulation
Symbol Native API (SNAPI) Status Handshaking
USB Country Keyboard Types (Country Codes)
USB Keystroke Delay
USB CAPS Lock Override
USB Ignore Unknown Characters
USB Ignore Beep Directive
USB Ignore Type Directive
Emulate Keypad
Emulate Keypad with Leading Zero
Troubleshooting on page
Appendix A, Standard Default Parameters
Parameter
USB Device Type on page
15-3.
for all user preferences, hosts, symbologies, and
Default
HID Keyboard Emulation
Enable
Enable
North American
No Delay
Disable
Enable
Honor
Honor
Disable
Disable
USB Interface 9 - 3
Figure 9-1 are examples
9-5.
Page Number
9-5
9-7
9-7
9-8
9-10
9-10
9-11
9-11
9-12
9-12
9-13