Mt20X0(S) To Cradle Support; Modes Of Operation; Point-To-Point Communication; Multipoint-To-Point Communication - Motorola MT2070 User Manual

MT20X0(s) To Cradle Support

Modes of Operation

The charging cradle with radio supports two radio communication modes of operation, allowing the device to
communicate wirelessly:
•
Point-to-Point
•
Multipoint-to-Point.

Point-to-Point Communication

In Point-to-Point communication mode, the cradle allows one device to connect to it at a time. In this mode, the
device is paired to the cradle either by insertion into the cradle (if pairing on contacts is enabled,
scanning the PAIR bar code on the cradle. Communication can be locked, unlocked (default), or in a lock override
state (see Pairing Modes on page
maintenance interval bar code beginning on
To activate this mode of operation, scan Point-to-Point.

Multipoint-to-Point Communication

In Multipoint-to-Point communication mode, up to seven devices can be paired to one cradle.
To activate this mode, the first device connected to the cradle must scan the Multipoint-to-Point bar code. This
mode allows a parameter broadcast
needs to be programmed.
To select Point-to-Point or Multipoint-to-Point mode, scan the appropriate bar code.
Multipoint-to-Point Mode

Parameter Broadcast (Cradle Host Only)

In both multipoint-to-point mode and single point mode, enable Parameter Broadcast to store parameter updates
from the cradle. Disable Parameter Broadcast to ignore parameter configurations that come up from the cradle. In
4-21). In locked mode, locking intervals must be set by scanning a connection
page 4-23.
(page 4-19) that clones all devices paired to the cradle so only one device
Radio Communications 4 - 19
*Point-to-Point Mode
page 4-22), or by