Insert The Device In The Cradle; Removing The Device From A Vertical Mount Cradle (Forklift Or Wall Mount); Charge The Device Battery In The Cradle; Charging Indicator/Led - Motorola MT2070 User Manual

Insert the Device in the Cradle

To insert the device in the cradle:
Insert the device into the cradle top first.
1.
Push the handle until it clicks into place, engaging the contacts in the cradle and device.
2.
Inserting the Device in the Single Slot Cradles
Figure 1-9
NOTE When inserting the device in a wall mounted cradle, ensure the device's hook recesses engage the hooks
on the wall mount adapter (when applicable).

Removing the Device from a Vertical Mount Cradle (Forklift or Wall Mount)

To remove the scanner from a vertically mounted cradle, remove the bottom of the scanner first then gently pull the
top of the scanner out of the cradle.

Charge the Device Battery in the Cradle

For best performance, fully charge the device battery before using the device for the first time. To charge the
device battery, place the device in the cradle (see
charging when the device LED indicator starts flashing green. (With the exception of several initial charge cycles,
the default state of the LED is off when the battery is fully charged.) A complete charge of a fully discharged battery
can take up to four hours using external power and up to 10 hours using the interface cable.
Charge within the recommended temperature of 32° to 104° F (0° to 40° C) nominal, 41° to 95° F (5° to 35° C)
ideal.
For information on maximizing battery life, see
NOTE The default state of the LED is off when the battery is fully charged with the exception of several initial
charge cycles. The LED may continually blink until the battery goes through several discharge cycles to
calibrate itself.

Charging Indicator/LED

The device has on screen charging indicators as well as an LED. The device's flashing green LED indicates
charging activity.
If the device displays
the battery. If one of these icons continues to display, contact Motorola Solutions Support. See
page 2-9 for descriptions of display icons.

Configure the Device

Use the bar codes in this manual to configure the device. See
Scanner Options, Chapter 6, Imaging Preferences
device using bar code menus.
Insert the Device in the Cradle on page
Battery on page
? or ? indicating a charging problem, remove the device from the cradle and replace
15-2.
Chapter 5, User Preferences & Miscellaneous
and each host chapter for information about programming the
Getting Started 1 - 13
1-13). The battery begins
Screen Icons on