Led Definitions - Motorola MT2070 User Manual

LED Definitions

In addition to beep sequences, the device uses a two-color LED to indicate status.
that display during scanning.
Standard LED Definitions
Table 3-2
LED
Hand-Held Scanning Standard Use
Off
Green
Red
Hands-Free (Presentation) Scanning Standard Use
Off
Momentarily Off
Green
Red
Parameter Programming
Green
Red
ADF Programming
Green
Blinking Green
Green after Blinking
Red
No power is applied to the device, or the device is on and ready to scan.
A bar code was successfully decoded.
Transmission error, conversion or format error, device malfunction or RS-232 receive
error.
No power is applied to the device.
A bar code was successfully decoded.
The device is on and ready to scan.
Transmission error, conversion or format error, or RS-232 receive error.
Number expected. Enter value using numeric bar codes.
Successful program exit with change in parameter setting.
Input error: incorrect bar code, programming sequence, or Cancel scanned.
Enter another digit. Add leading zeros to the front if necessary.
Enter another alphabetic character or scan the End of Message bar code.
All criteria or actions cleared for current rule, continue entering rule.
Delete last saved rule. The current rule is left intact.
All rules deleted.
Enter another criterion or action, or scan the Save Rule bar code.
Rule saved. Rule entry mode exited.
Cancel rule entry. Rule entry mode exited because of an error or the user asked to exit
rule entry.
Out of rule memory. Erase some existing rules, then try to save rule again.
Entry error, wrong bar code scanned, or criteria/action list is too long for a rule. Re-enter
criterion or action.
Table 3-2
Indication
Scanning 3 - 3
defines LED colors