Stop Bit Select; Data Bits - Motorola MT2070 User Manual

8 - 10 MT2070/MT2090 User Guide

Stop Bit Select

The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and
prepares the receiving device for the next character in the serial data stream. Select the number of stop bits (one or
two) based on the number the receiving terminal is programmed to accommodate. Set the number of stop bits to
match host device requirements.
*
1 Stop Bit

Data Bits

This parameter allows the device to interface with devices requiring a 7-bit or 8-bit ASCII protocol.
*
-Bit
2 Stop Bits
7-Bit