Sun Microsystems IB Switch 9P Administration Manual page 97

CLI Messages (Continued)
TABLE A-6
Message
Initial state for user admin has no
permissions: enter 'password' to set
password and enable full permissions.
Error: User name specified is too long
Error: Invalid username string
Deleted user %s successfully.
Image too large for flash location
Flash segment out of range
SRecord address out of range
fru: Operation invalid
fru: Waiting for FRU to be configured.
Press control-C to abort operation.
Unknown Flash Image
flashupdate of %s failed
Error: Invalid FRU name string - type
showplatform for list of FRUs.
Error: Invalid command options
Error: Invalid command string - type help
for a list of commands.
Do not issue a resetsc, setfailover, or
power cycle to this system. You MUST
first successfully complete a
flashupdate of the SC bootrom before
doing so, otherwise this system will
require a hardware level flash.
flashupdate: Checksum failed
Bad SRecord
%s: Cannot power on.
Password must differ from old one by at
least 3 characters.
Password too short (Must be at least 6
characters).
Description
The default user admin has no permissions right after
the switch is shipped. A password has to be assigned
to it.
Corrupted flash image.
Corrupted flash image.
Corrupted flash image.
Operation is not supported on this FRU.
Power operation attempted while the FRU is being
brought up. Either wait for a while or stop the
operation using Ctrl-C.
Corrupted flash image.
Flashupdate failed for reason mentioned in the line
preceding this message.
Wrong FRU given as parameter.
Non-existent command option entered.
Wrong command name given.
Flashupdate of bootrom or the whole flash failed. The
switch must not be reset, because it will not be able to
boot. Flashupdate has to be repeated until bootrom is
successfully programmed.
Wrong image file checksum.
Image file provided to flashupdate command is not a
valid S-record image.
Power on failed for reason given in preceding lines.
Wrong password given using password command by
user without u permission.
Wrong password given using password command by
user without u permission.
Appendix A Troubleshooting 67