Resetsc Command Options - Sun Microsystems IB Switch 9P Administration Manual

The system responds with the following message:
Are you sure you want to reset the SC [y/n]?
2. Type y to proceed, or n to exit without resetting the switch.

resetsc Command Options

The resetsc command uses two options: -y or -F
If you use the -y option, the reset proceeds without first asking you to confirm the
reset.
If you use the -F option, the reset command forces a reset. Forces the reset
regardless of the state of the switch. (For example, without this option resetting the
switch would not be permitted while ALOM is logging to a PSU's FRUID.)
setbp
Use the setbp command to set a Blueprint of the switch. The switch is shipped with
Blueprint set to a managed single switch configuration using the IP address of the
switch as basic for the subnet prefix. See Appendix D for more information about
Blueprints.
24 Sun IB Switch 9P Administration Guide • October 2006