To Use The Logout Command; To Use The Password Command - Sun Microsystems IB Switch 9P Administration Manual

logout
Use the logout command to end your session and close your serial or Telnet
connection.
▼

To Use the logout Command

Note – You do not need user permissions to use this command.
●
At the sc> prompt, type the following command:
sc> logout
password
Use the password command to change the password for the account to which you
are currently logged in. This command works like the UNIX passwd(1) command.
▼

To Use the password Command

Note – This command enables you to change the password for your own account.
You do not need user permissions to use this command. If you are an administrator
and want to change a user account's password, use the userpassword command.
See "userpassword" on page 48
●
At the sc> prompt, type password.
When you use this command, ALOM prompts you for your current password. If you
enter the password correctly, it prompts you twice to enter the new password.
For example:
sc> password
Enter current password:
Enter new password:
Enter new password again:
New password set for user admin successfully
sc>
for more information.
Chapter 3 Command-Line Reference 19