Sun Microsystems IB Switch 9P Administration Manual page 92

Table of Contents

Advertisement

Syslog Messages (Continued)
TABLE A-3
Message
IBSRM_EVENT_NODE_PROG_FAILED,
port_GUID =port-GUID, IB port
number port/connector number
connector
IBSRM_EVENT_PORT_NO_MORE_LIDS,
port_GUID = port-GUID
IBSRM_EVENT_TOO_SMALL_LFT, switch
GUID switch-GUID, max lids supported
max-supported-lids, max lid in use
max-lid
IBSRM_EVENT_PORT_DUPLICATE_GUID,
duplicate GUID = GUID-value,
original peer switch GUID switch-
GUID-1, duplicate peer switch
GUID switch-GUID-2, original peer IB
port port1, duplicate peer IB port
port2
IBSRM_EVENT_MCG_CREATED, mclid =
mc-lid-value
IBSRM_EVENT_MCG_DELETED, mclid =
mc-lid-value
IBSRM_EVENT_SM_BECAME_MASTER,
sm_GUID = GUID-value
62
Sun IB Switch 9P Administration Guide • October 2006
Severity
Description
Warning
Even after several attempts, the
node/port port-GUID could not be
programmed (setup for proper IB
usage). Check cabling and connections.
If cabling seems to be OK reboot the
device.
Error
The port identified by port-GUID could
not be owned/managed because the
management software ran out of LIDs it
is allowed to use. This should not
happen unless the switch is part of an
extremely large IB network, which is not
supported.
Error
The switch identified by switch-GUID
cannot be programmed with wanted
LID value max-lid because this LID is
beyond the size of the switch forward
table max-supported-lids. Any packets
addressed for max-lid will fail to transfer
through the indicated IB switch.This
should not happen unless the switch is
part of an extremely large IB network,
which is not supported.
Error
Duplicate ports in the IB topology have
the same GUID value GUID-value. One
instance is connected to switch-GUID-1
port1 while the other is connected to
switch-GUID-2 port2. The IB subnet will
most likely perform badly since unique
GUID values are central for correct IB
management. The only way to correct
this is to exchange one of the indicated
devices with another one having a
proper GUID.
Information
The multicast group identified by
multicast lid mc-LID-value has been
created.
Information
The multicast group identified by
multicast lid mc-LID-value has been
deleted.
The master SM in the IB subnet is
Information
running behind the port identified by
GUID-value.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the IB Switch 9P and is the answer not in the manual?

Table of Contents