System Log Informational Messages From The Platform - Sun Microsystems IB Switch 9P Administration Manual

System Log Error Messages from the Platform (Continued)
TABLE A-1
Message
Platform PCA9554@40
init FAILED
Platform PCA9554@42
init FAILED
Platform PCA9554 init
on Mezzanine FAILED
Platform PSUnumber init
failed
Platform Ibdevice init
failed
ASSP init failed
Platform External
loopback mode on port
number FAILED, not
Link up or 12X.
Platform External
loopback mode on port
number FAILED, sent xx
received yy
Platform External
loopback mode on port
number FAILED, not
Link up or 12X.
Platform External
loopback mode on port
number FAILED, sent xx
received yy
TABLE A-2

System Log Informational Messages from the Platform

TABLE A-2
Message
Platform Sun IB Switch 9 port
platform init started
Platform Last reset was done by WDOG
58 Sun IB Switch 9P Administration Guide • October 2006
Description
Hardware fault during boot
Hardware fault during boot
Hardware fault during boot.
Hardware fault during boot
Software fault during boot
Hardware fault during boot
Loopback test failed during boot
Loopback test failed during boot
Loopback test failed during boot
Loopback test failed during boot
shows informational messages from the platform.
Description
The init of the platform has started.
The switch was rebooted by the watchdog due to a hang of
the system.
Solution
Try rebooting. If the same error
message reappears, contact service.
Try rebooting. If the same error
message reappears, contact service.
Try rebooting. If the same error
message reappears, contact service.
Try rebooting. If the same error
message reappears, replace the PSU.
Try rebooting.
Try rebooting. If the same error
message reappears, contact service.
The port number might be bad.
Try rebooting. If the same error
message reappears, avoid using that
port.
The port number might be bad.
Try rebooting. If the same error
message reappears, avoid using that
port.
The port number might be bad.
Try rebooting. If the same error
message reappears, avoid using that
port.
The port number might be bad.
Try rebooting. If the same error
message reappears, avoid using that
port.