Sun Microsystems IB Switch 9P Administration Manual page 100

General Error Messages (Continued)
TABLE A-8
Error Message
Error: Inconsistent passwords entered.
Error: invalid password entered.
Password must be 6-8 characters, differ
from the previous by at least 3
characters and contain at least two
alphabetic characters and at least one
numeric or special character.
Error: invalid username string. Please
re-enter username or type 'usershow' to
see a list of existing users.
Error displaying user username
Error: Invalid IP address for gateway
address and IP netmask.
Error: Invalid IP gateway for IP address
and IP netmask.
Error setting permission for username
Error: Invalid username string. Please
re-enter a username of no more than 16
bytes consisting of characters from the
set of alphabetic characters, numeric
characters, period (.), underscore (_),
and hyphen (-). The first character
should be alphabetic and the field
should contain at least one lower case
alphabetic character.
Failed to get password for username
Invalid login
Invalid password
Invalid permission: permission
70 Sun IB Switch 9P Administration Guide • October 2006
Command/Description
During execution of the userpassword command, you
typed the password differently the second time than you
did the first time you were prompted. Execute the
command again.
You entered an invalid password. Refer to the password
restrictions and then enter the password again.
You tried to specify an ALOM user account that is not on
the list of user accounts. To see a list of valid user
accounts, use the usershow command.
An error occurred during execution of the usershow
command. This message is followed by a more detailed
message that explains the nature of the error.
Check that the addresses are correct, and then run
setupsc again.
Check that the addresses are correct, and then run
setupsc.
An error occurred during execution of the userperm
command. This message is followed by a more detailed
message that explains the nature of the error.
You entered an invalid username. Review the proper
syntax for user names and try again.
During execution of the userpassword command, an
SEEPROM error occurred. Try executing the command
again.
Login attempt failed. This message appears at the login
prompt.
You entered an invalid password with the userpassword
command.
You entered an invalid user permission.