To Use The Setbp Command - Sun Microsystems IB Switch 9P Administration Manual

▼

To Use the setbp Command

1. At the sc> prompt, type the following command:
sc> setbp option
CODE EXAMPLE 3-1
configuration.
CODE EXAMPLE 3-1
sc> setbp
Entering Interactive mode.
Use Ctrl-z to exit & save. Use Ctrl-c to abort.
Should this switch run IB management software [y/n]: y
What is max number of hosts in the configuration [0/9/12/18]: 9
Which subnet number is this switch part of [value]: 1
The new blueprint setting is saved
The system must be reset (using resetsc) for the new setting to
become active
CODE EXAMPLE 3-2
configuration.
CODE EXAMPLE 3-2
sc> setbp
Entering Interactive mode.
Use Ctrl-z to exit & save. Use Ctrl-c to abort.
Should this switch run IB management software [y/n]: y
What is max number of hosts in the configuration [0/9/12/18]: 18
Which subnet number is this switch part of [value]: 1
Is this switch a top switch [y/n]: y
The new blueprint setting is saved
The system must be reset (using resetsc) for the new setting to
become active
CODE EXAMPLE 3-3
shows a sample of the setbp command for a 9-node
Sample of the setbp Command for 9 Nodes
shows a sample of the setbp command for an 18-node
Sample of the setbp Command for 18 Nodes
shows a sample of the setbp command for a 9-node
Chapter 3 Command-Line Reference 25