To Use The Showlogs Command - Sun Microsystems IB Switch 9P Administration Manual

If you use the showlogs command without any option, ALOM displays the last 20
lines of the event log.
▼

To Use the showlogs Command

Note – You do not need user permissions to use this command.
●
At the sc> prompt, type the following command:
sc> showlogs option(s)
where option(s) is the desired option(s), if any.
The following example shows an event log entry:
NOV 15 11:12:25: MAJOR: PS1: Fan0 fan speed fault.
Note – Timestamps shown in the ALOM event log reflect UTC (Coordinated
Universal Time).
This example shows the output of the showlogs command for PS0 and PS1.
CODE EXAMPLE 3-9
sc> showlogs PS0 PS1
----------------------------------------------------------------
PS0
----------------------------------------------------------------
Jan 01 00:00:04: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:04: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:04: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Jan 01 00:00:05: MINOR: PS0: Environmental monitoring enabled.
Sample of showlogs Command
Chapter 3 Command-Line Reference 41