To Use The Setdefaults Command; Setdefaults Command Options - Sun Microsystems IB Switch 9P Administration Manual

TABLE 3-7
Option
.SS
cc
yy
setdefaults
Use the setdefaults command to set all configuration variables back to their
factory default values.
▼

To Use the setdefaults Command

Note – You must have a level user permission to use this command. See
"userperm" on page 49
the password to execute permission-level commands.
1. At the sc> prompt, type the following command:
sc> setdefaults
Are you sure you want to reset the SC configuration (y/n)? y
Note: Please reset your ALOM to make the new configuration active.
2. Type the resetsc command to reset ALOM:
sc> resetsc
This completes returning the variables back to the factory default values.

setdefaults Command Options

The setdefaults command uses the following option.
TABLE 3-8
Option
-y
28 Sun IB Switch 9P Administration Guide • October 2006
setdate Command Options (Continued)
Description
Seconds
Century (first two digits of the year)
Year (last two digits of the year)
for information on setting user permissions. You must set
setdefaults Command Options
Description
Proceeds without first asking the confirmation question: Are you
sure you want to reset the SC configuration?