Removefru Command Option; To Use The Resetsc Command; Removefru Fru Values - Sun Microsystems IB Switch 9P Administration Manual

For example, to prepare power supply 0 for removal, type:
sc> removefru PS0
Are you sure you want to remove PS0 (y/n)?: y
Mar 03 22:10:22: CRITICAL: PS0 removed - replace within 10 minutes
of removal
Caution – Removing one of the PSUs leaves the switch without a failover power
supply. Be sure to replace the PSU as soon as possible to ensure failover capability.

removefru Command Option

The removefru command has one parameter: fru.
Specifying the fru parameter prepares the specified FRU for removal.

removefru FRU Values

TABLE 3-5
Value
PS0
PS1
resetsc
Use the resetsc command to perform a hard reset of the switch. This terminates all
current switch sessions.
▼

To Use the resetsc Command

Note – You must have r level user permission to use this command. See
"userperm" on page 49
1. To perform a reset, type the following command:
sc> resetsc option
where options are -y or -F, if desired.
Description
Prepares power supply 0 in the switch for removal.
Prepares power supply 1 in the switch for removal.
for information on setting user permissions.
Chapter 3 Command-Line Reference 23