Descriptions Of Cli Commands - Sun Microsystems IB Switch 9P Administration Manual

List of CLI Shell Commands by Function (Continued)
TABLE 3-1
CLI Command
flashupdate
poweroff
poweron
showlocator
setlocator
removefru
help
resetsc
logout
setbp
showbp
showib

Descriptions of CLI Commands

The following pages provide full descriptions of the shell commands in alphabetical
order.
flashupdate
Use the flashupdate command to install a new version of the firmware from a
location that you specify. The values you enter for command options specify the IP
address of the site from which you download and the path at which the firmware
image is located.
Summary Description
Updates the ALOM firmware. This command
downloads main and bootmonitor firmware
images to ALOM.
Removes the main power from the PSU.
Applies the main power to the PSU.
Displays the current state of the Locator LED as
either on or off.
Turns the locator LED on or off.
Prepares a FRU (for example, a power supply)
for removal, and illuminates the management
system's OK-to-Remove indicator light.
Displays a list of all ALOM commands with their
syntax and a brief description of how each
command works.
Reboots ALOM.
Logs out from an ALOM shell session.
Sets the Blueprint of the switch. (See Appendix D
for more information about Blueprints)
Displays the running and stored Blueprints of the
switch. (See Appendix D for more information
about Blueprints)
Displays InfiniBand switch status.
Full Description
"flashupdate" on page 15
"poweroff" on page 20
"poweron" on page 21
"showlocator" on page 40
"setlocator" on page 29
"removefru" on page 22
"help" on page 17
"resetsc" on page 23
"logout" on page 19
"setbp" on page 24
"showbp" on page 31
"showib" on page 37
Chapter 3 Command-Line Reference 15