None Blueprint - Sun Microsystems IB Switch 9P Administration Manual

The switch that only connects to other switches is denoted as the top switch and will
always be the master management node. The other switches are denoted bottom
switch. These terms are used when the blueprint settings are displayed through the
showbp command.
Setting Up an 18-Node Blueprint on the Top Switch
CODE EXAMPLE D-3
sc> setbp
Entering Interactive mode.
Use Ctrl-z to exit & save. Use Ctrl-c to abort.
Should this switch run IB management software [y/n]: y
What is max number of hosts in the configuration [0/9/12/18]: 18
Which IB subnet ID is this switch part of [value]: 15
Is this switch a top switch [y/n]: y
The new blueprint setting is saved
The system must be reset (using resetsc) for the new setting to become active
sc>
Setting Up an 18-Node Blueprint on the Bottom Switches
CODE EXAMPLE D-4
sc> setbp
Entering Interactive mode.
Use Ctrl-z to exit & save. Use Ctrl-c to abort.
Should this switch run IB management software [y/n]: y
What is max number of hosts in the configuration [0/9/12/18]: 18
Which IB subnet ID is this switch part of [value]: 15
Is this switch a top switch [y/n]: n
The new blueprint setting is saved
The system must be reset (using resetsc) for the new setting to become active
sc>

none Blueprint

The none blueprint does not have any topology size parameter. This blueprint can
only be used temporarily before configuring for the proper topology. When the none
blueprint is active, the management software will find out what the topology looks
Appendix D Blueprints 89