Lan (Pppoe Connections) - Sony Ipela PCS-XG80 Operating Instructions Manual

Setup > LAN > NAT Setup
The setting has been configured properly if the correct WAN IP address
appears in the Home menu.
To display the NAT address in the Home menu, you must set "Number
Display" to "NAT: Address" in the Home Menu1 page of the General
setup menu (page 70).
3
Remote parties must configure the Basic Setup page in the LAN setup
menu in the same way.
Note
Remote parties do not need to configure the settings in the NAT Setup page of the
LAN setup menu as they are not in a NAT environment.
To connect to a remote party
Select "IP" under "Line I/F", enter the remote party's IP address, and dial.
Note
When using the terminal in the NAT environment, you can connect to a remote party
(global IP), but for a remote party to connect to you, you must configure your router
settings. For details on router settings, consult with the system administrator.

LAN (PPPoE Connections)

When using PPPoE, you can connect via LAN without a router.
A modem (using bridge mode) is required when using FLET'S ADSL.
Configuration example
/
210.10.10.10
IP:192.168.0.11
LAN3 NAT Mode
WAN IP Address
B FLET'S
Local IP
network
ONU
5/11/2008 13:00
On
210. 10. 10. 1
Save Cancel
Internet
B FLET'S
ONU
/
211.10.10.10
Setting Up the Network Configurations
85