Lan Connection Using Pppoe (Lan1/Lan2) - Sony Ipela PCS-XG80S Operating Instructions Manual

LAN Connection Using PPPoE (LAN1/LAN2)

When using PPPoE, you can connect via LAN without a router.
A modem (using bridge mode) is required when using FLET'S ADSL.
Configuration example
/
210.10.10.10
1
Set "PPPoE" to "LAN1" or "LAN2" under the PPPoE page in the LAN
setup menu, and enter the PPPoE user name and PPPoE password given to
you by the provider.
Setup
2
If you have a fixed IP from the provider, set "Fixed IP for PPPoE" to "On",
and enter your fixed IP address for PPPoE in "Fixed IP Address for
PPPoE" under the PPPoE page in the LAN setup menu.
The setting has been configured properly if the correct IP address appears
in the Home menu.
Note
If the fixed DNS server address is specified by the provider, set "DNS" to
"Specify", and enter the specific addresses in "Primary DNS" and "Secondary
DNS".
3
Remote parties must configure in the same way.
To connect to a remote party
Select "IP" under "Line I/F", enter the remote party's IP address, and dial.
B FLET'S
Local IP
network
ONU
LAN PPPoE
LAN2
PPPoE
User Alias
Password
Fixed IP for PPPoE
Fixed IP Address for PPPoE
DNS
Primary DNS
Secondary DNS
Internet
B FLET'S
ONU
/
211.10.10.10
LAN1
Sony@aaa.ne.jp
abcdefg
On
210. 10. 10. 10
Obtain automatically
Save Cancel
Setting Up the Network Configurations
103