Ending the Conference
1
Press the DISCONNECT (
The message "Disconnect?" appears on the monitor screen.
2
Press the V, v, B or b button on the Remote Commander to select "OK",
then press the ENTER button, or press the DISCONNECT (
the Remote Commander again.
The system is disconnected.
Note
The power of the Communication System remains on even if the system is
disconnected.
To cancel disconnection of the system
Select "Cancel" with the V, v, B or b button on the Remote Commander, then
press the ENTER button.
To register the connected remote party in the Phone Book
You can easily register the remote party who has just disconnected.
If you set "Last Number Registration" to "On" on the Device Setup page of the
General setup menu, the message "Register this participant in the list?"
appears after a communication with an unregistered remote party is finished.
When you select "OK", the Edit List menu appears.
Note
If the "Last Number Registration" is set to "Off", the message does not appear.
For "Last Number Registration" setting, see "General Setup Menu" on page
70.
) button on the Remote Commander.
Ending the Conference
) button on
101
Comments to this Manuals
Latest comments: