Programming The Remote Commander To Operate The Camera Unit - Sony Ipela PCS-XG80 Operating Instructions Manual

• If battery leakage occurs, clean the battery compartment and replace all the
batteries with new ones.

Programming the Remote Commander to Operate the Camera Unit

The supplied Remote Commander controls the HD Visual Communication
System using the radio frequency of 2.4 GHz. The Remote Commander and
the Communication System are paired to prevent interference from other
Remote Commanders and Systems.
Pairing between the Remote Commander and the Communication System is
programmed at the factory. If the Communication System is located apart from
the Remote Commander, it may not be controlled according to the condition
of reception. In this case, perform the procedure below to pair the Camera Unit
with the Remote Commander.
Note
When performing pairing procedure, be sure to turn off other HD Visual
Communication Systems or HD Camera Units located nearby that are not targets for
pairing. If multiple devices are turned on, the Remote Commander might pair device
other than the target one.
To pair the Camera Unit with the Remote Commander
1
Press the
The /
?
indicator lights in green when the Communication System turns on.
2
Set "RF Remote Control Reception" to "Camera" in the General setup
menu.
32
Preparing the System
POWER/STANDBY
LED indicator
PRESENTATION
/ /
F1 F2 F3 F4
4
LAYOUT VIDEO INPUT CAMERA
VOLUME ZOOM
T
ENTER
3
W
RETURN TOOLS
BACK
CONNECT SPACE DISCONNECT
1 2 3
ABC DEF
4 5 6
GHI JKL MNO
7 8 9
PQRS TUV WXYZ
TONE DOT
0
ON/OFF
MIC
? / 1 (power) switch on the Communication System to turn it on.
(power) indicator on the Communication System flashes. The
1
? 1
/ (power) indicator
/
1
OPEN