Lan (Pppoe Connections) - Sony PCS-1 Operating Instructions Manual

LAN Setup
Page: 4/11
The setting has been configured properly if the correct NAT address appears in
the launcher menu.
To display the NAT address in the launcher menu, you must set "Number
Display" to "NAT: Address" under page 4/4 of the General Setup menu (page
48).
3
Remote parties must configure under Page 1/11 of the LAN Setup menu in
the same way.
Note
Remote parties do not need to configure the NAT settings in the LAN Setup menu
as they are not in a NAT environment.
To conduct a videoconference
Select "IP" under "Line I/F", enter the remote party's IP address, and dial.
Note
When using the terminal in the NAT environment, you can connect to a remote party
(global IP), but for a remote party to connect to you, you must configure your router
settings. For details on router settings, consult with the system administrator.

LAN (PPPoE Connections)

When using PPPoE, you can connect via LAN without a router.
A modem (using bridge mode) is required when using FLET'S ADSL.
Configuration example
ON LINE POWER LAN ALERT
210.10.10.10
78
Setting Up the Network Configurations
NAT Mode
On
210.10.10.1
NAT Address
Packet Resend Request
On
Adaptive Rate Control
On
LAN Mode
Auto Negotiation
Save
B FLET'S
Internet
Local IP
network
ONU
Cancel
B FLET'S
ONU
ON LINE POWER LAN ALERT
211.10.10.10