Sony Ipela PCS-XG80 Operating Instructions Manual page 59

H.239 Ratio
When H.239 presentation transmissions are
made with the system, the H.239
presentation data shares bandwidth with
camera images that are also being sent. This
setting allows you to select how much of the
total bandwidth to use for H.239
presentation data transmissions.
2/3: Use 2/3 of the total bandwidth for H.239
presentation data transmissions.
1/2: Use 1/2 of the total bandwidth for H.239
presentation data transmissions.
1/3: Use 1/3 of the total bandwidth for H.239
presentation data transmissions.
Restrict
Allows you to select the ISDN transmission
rate.
Auto: Select when connecting a remote
party via a normal ISDN line.
56K: Select when connecting a remote party
located in a region or country where the
ISDN transmission rate is 56 Kbps.
Note
The system is set to connect an ISDN line at the
transmission rate of 64 Kbps by default.
However, some countries, such as the USA,
and some regions may use the ISDN
transmission rate of 64 Kbps and 56 Kbps. You
may not communicate with such countries or
regions at 64 Kbps, so you must therefore set
"Restrict" to "56K" before dialing.
Screen Size
Allows you to select the screen size of the
picture to be transmitted or received.
You can select from among W4CIF,
W432P, WCIF, 4CIF, CIF, QCIF and
AUTO.
Video Mode
Allows you to select the compression format
of pictures to be transmitted or received.
You can select from among H.261, H.263+,
and H.264.
Video Frame
Allows you to select the number of video
frames during transmission or reception.
15fps: Send CIF format pictures at a
maximum rate of 15 frames per second.
30fps: Send CIF format pictures at a
maximum rate of 30 frames per second.
60fps: Send CIF format pictures at a
maximum rate of 60 frames per second.
AUTO: Switch the number of frames
automatically.
Communication
SIP: Mode
Communication Bit Rate
Allows you to select the communication bit
rate per point
You can select from among 128Kbps,
384Kbps, 512Kbps, 1Mbps, 2Mbps, 3Mbps,
4Mbps, 5Mbps, 6Mbps, 7Mbps, 8Mbps,
9Mbps, 10Mbps and Other.
Selecting "Other" allows you to enter up to
10 Mbps.
Audio Mode
Allows you to select the compression format
of audio to be sent to a remote party.
You can select from among G.728, G.722
and G.711.
Note
When the remote system does not support the
audio mode selected by the local site, the mode
automatically becomes "G.711".
Far End Camera Control
Allows you to select whether to enable the
control of each other's cameras from each
other's site.
On: Enables the control of each other's
cameras. Normally, set to "On".
Off: Disables the control of each other's
cameras.
Screen Size
Allows you to select the screen size of the
picture to be transmitted or received.
You can select from among 720, W4CIF,
W432P, WCIF, 4CIF, CIF, QCIF and
AUTO.
Video Mode
Allows you to select the compression format
of pictures to be transmitted or received.
You can select from among H.261, H.263+,
H.264 and MPEG4.
Registering Local Information
59