The stored video input is not deleted even after the system is turned off, and
is selected when the power is turned on again.
To change the video input name displayed in the Video Input menu
You can label the desired name for each video input on the Custom Input Label
page in the Video setup menu. When you switch the video input in step 2
above, the name you set is displayed in the Video Input menu.
For example, you can label: Camera1, Camera2, None, etc.
For details, see"Custom Input Label" in the Video setup menu on page 62.
Switching the Sound to Be Sent to the Remote Party
You can switch the sound sent to the remote party between the sound from the
microphone and that from the connected equipment. Use "Input Select" in the
Audio setup menu.
For details, see "Input Select" in the Audio setup menu on page 60.
Switching Video and Audio at the Same Time
Set "Link to Audio Input" to "On" on the Link to Mic page of the Video setup
menu. When you switch the video input, the audio input automatically
switches to the one which has been set to link to the switched video input.
For details, see"Link to Mic" in the Video setup menu on page 62.
Switching the Picture from the Remote System
You can switch the picture output from the remote system during
Press the VIDEO INPUT button, then F1 button on the Remote Commander.
The Video Input > Far menu appears.
Video Input > Far
Use the V, v, B or b button on the Remote Commander to select the picture
output from the equipment connected to the remote system, then press the
ENTER button. The selected picture is input to the local system and is
displayed on the monitor screen.
You can only select the picture that can be output from the remote system.
Selecting the Input Picture and Sound
Sub Document Camera