Sony Ipela PCS-XG80 Operating Instructions Manual page 184

Symptom
No picture.
No connection.
184
Troubleshooting
Cause
The selected picture source is not
tuned on.
Video input is not selected properly. Select the video input properly (page
The selected picture source is not
correctly connected to the system.
A voice meeting is held.
Movement of the camera is
prevented.
Wrong number was dialed.
The setting of "Line I/F" is not
correct (when using direct dialing).
The registered items in the Phone
Book are not correct.
Some of the system settings are not
correct.
The IP address and network mask
are not set correctly (when using
LAN).
The LAN cable is connected to the
2 connector.
The LAN or ISDN cable is
disconnected.
The LAN or ISDN cable is
connected to the incorrect
connector.
The LAN or ISDN cable is down.
The cable exclusively designed for
the ISDN connection is used for
LAN connection (when using
LAN).
Incorrect type of cable (cross or
straight cable) is used for the LAN
or ISDN connection.
The DSU is turned off (when using
ISDN).
Solution
Turn on the selected video equipment.
120).
Check the connections (page 149).
This is not a malfunction.
Turn off the system, then turn it on
again.
Check the entered number.
Set "Line I/F" to correct interface
referring to "Calling a Remote Party"
(page 90).
Register the party correctly referring
to "Registering a Remote Party –
Phone Book" (page 102).
Set the system settings correctly
referring to "Registering Local
Information" (page 53).
Ask the system administrator to set
them correctly (page 63).
Connect the cable to the
connector (page 27).
The 2 connector cannot be used
with the system of this version. It can
be used with the system of an
upgraded version.
Connect correctly (pages 27, 28).
Connect correctly (pages 27, 28).
Replace the cable with a new one.
Use the cable for LAN connection.
Use the correct type of cable.
Turn on the DSU.
1