See pages 109 to 118 to adjust the sound and picture during communication.
To receive a call in manual answer mode
When you receive a call, the Communication System rings and the message
"Incoming call. Answer?" appears on the monitor screen.
Press V, v, B or b to select "OK", then press the ENTER button. The system
is then connected. Once the connection is made, the picture of the remote party
is displayed on the local monitor screen and the sound is heard. The picture and
sound on the local site will be enabled on the remote site at the same time.
The message "Session Connected" appears on the monitor screen.
You are now ready to start a communication.
See pages 109 to 111 to adjust the sound and picture during communication.
When you do not want to answer the call
Press V, v, B or b to select "Cancel", then press the ENTER button. Ringing
stops, and the connection is canceled.
When the system fails to make an ISDN connection
If the system fails to connect to the remote party, the message "Cannot
complete connection (an ISDN cause code and a message are displayed here)"
appears on the monitor screen.
For details on ISDN cause codes and messages, see "On-Screen Messages"
on page 181.
Receiving a Call from a Remote Party