Lan (Pppoe Connections) - Sony IPELA PCS-HG90 Operating Instructions Manual

To display the NAT address in the launcher menu, you must set "Number
Display" to "NAT: Address" under Page 3/3 of "Launcher screen" in the
General Setup menu (page 49).
3
Remote parties must configure Page 1/2 of the General screen in the LAN
Setup menu in the same way.
Note
Remote parties do not need to configure the settings in the NAT/Port screen of the
LAN Setup menu as they are not in a NAT environment.
To connect
Select "Single" under "Dial Mode", enter the remote party's IP address, and
dial.
Note
When using the terminal in the NAT environment, you can connect to a remote party
(global IP), but for a remote party to connect to you, you must configure your router
settings. For details on router settings, consult with the system administrator.

LAN (PPPoE Connections)

When using PPPoE, you can connect via LAN without a router.
A modem (using bridge mode) is required when using FLET'S ADSL.
Configuration example
210.10.10.10
* Optical Network Unit
ONU*
Internet
Local IP
network
B FLET'S
ONU*
B FLET'S
211.10.10.10
Setting Up the Network Configurations
69