On-Demand Mode Printing; Printing An Error Label; Pausing A Batch - Monarch 9855 Operator's Handbook Manual

O n - D e m a n d M o d e P r i n t i n g
When this printer is operating in the on-demand mode, the next label prints when the previous
label is removed from the printer or when Feed/Cut is pressed. The display shows "Printing X
of Y" until all the labels in the batch are printed.
If you have purchased the optional peel module, you must use on-demand printing with peel
mode. If you are using peel mode, remove the excess backing paper by pulling up across the
saw-toothed tear edge. Make sure the backing paper tears at the edge. Hold the leading edge
of peeled labels when printing on stock longer than six inches. The minimum feed length for
peel mode is 1.5 inches. You must use non-perforated supplies for peel mode. The maximum
speed for peel mode is 8.0 ips.
Note: We recommend using 0.5-inch gap supplies in peel mode when backfeed is disabled.

Printing an Error Label

If the printer displays a data error (errors
0-499), press Feed to print an error label
and continue printing. See your System
Administrator about the error label.
P a u s i n g a B a t c h
You can pause printing by pressing Enter/Pause. You may want to interrupt a batch to make
adjustments for:

Loading a different roll of supply or a ribbon. See Chapter 2, "Loading Supplies" or Chapter
3, "Loading Ribbon" for more information.

Adjusting the supply position or contrast using the Setup menu. See Chapter 4, "Setting
Supply Options" for more information.
When you press Enter/Pause you will see
PAUSE MENU
 Print Mode
You can press Enter/Pause to resume printing or press  or  to display the Pause Menu
options.
The following chart shows the Pause Menu options.
9-2 Operator's Handbook

Pause Menu
Canc el
Canc el
All
B a tch
Prin t Restart
Mode B a tch