Monarch 9855 Operator's Handbook Manual page 15

Adjust the supply holder guides so the sides barely touch the roll. Make sure the supply
5.
roll turns freely.
If you are using fan-fold supplies, place the supply stack behind the printer, label
side facing up.
6. Push down on the supply lever to unlock the supply guides.
Lay the label strip across the supply guide so that a few inches extend past the front of the
7.
printer. Tuck the supply under the nibs and in between the die cut sensor. Do not feed
supply between the supply roller and deflector.
For fan-fold supplies, lay the label strip over the supply holder and across the supply
guide so that a few inches extend past the front of the printer. Tuck the supply under
the nibs and in between the die cut sensor.
Supply Holder
Guides
Supply Roller
Loading Supplies 2-3