Verifier - Monarch 9855 Operator's Handbook Manual

Press Enter/Pause. The current setting is displayed, for example:
3.
Enter contrast
[-699/+699]: +0
Press  or  to change the contrast. Pressing  darkens the print;  lightens the print.
4.
Feed/Cut acts as a toggle switch to change the value by 10 or 1. For example, to make
the contrast 50 (from the default of 0), press Feed/Cut, then press  five times (50).
5. Press Enter/Pause to select either "Yes" or "No" to print a test label and check the print
contrast. Press Enter/Pause.
Press Escape/Clear until you see the Main Menu.
6.
We recommend you check the bar code print quality with a bar code verifier. If you do not
have a bar code verifier or scanner, check the bar code visually. A bar code that is in spec
has complete bars, clear spaces, and small alphanumeric characters look complete. An in spec
bar code may not look as good as one that is too dark, but it has the highest scan rate.
Dark
V e r i f i e r
The verifier scans and checks the quality of bar codes as they are printed. The optional
verifier must be purchased separately. The verifier scans parallel bar codes; it can not scan
serial bar codes or read the RFID data programmed into the label.
The verifier must be enabled and set up before you can scan bar codes. For set up
procedures, refer to your verifier's Operating Instructions available on our Web site.
To enable the verifier, from the Main Menu, select Setup, then Verifier. Then follow these
steps.
Press  or  until you see
1.

VERIFIER

 State
2. Press Enter/Pause. The current setting is displayed, for example:
VERIFIER
Disabled
Press  or  to see the other option. After you display the option you want, press
3.
Enter/Pause. Press Escape/Clear until you see the Main Menu.
4-16 Operator's Handbook
IN SPEC

Light