F e e d M o d e
You can use continuous or on-demand printing. On-demand printing allows you to remove a
label before printing the next one.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
Press or until you see
1.
SUPPLY
Feed Mode
2.
Press Enter/Pause to set the feed mode. The current setting is displayed, for example:
FEED MODE
Continuous
Press or to see the other option. After you display the option you want, press
3.
Enter/Pause. Press Escape/Clear until you see the Main Menu.
B a c k f e e d
Backfeed works by advancing each printed label to the desired dispense position. Once that
label is removed, the next label to be printed is backed up underneath the printhead. In
continuous mode, only the last label in the batch is advanced to the dispense position.
Extended backfeed is available on this printer with a knife installed. Extended backfeed feeds
a tag far enough out to be cut and backfeeds the next tag to the printhead line.
Note:
We recommend using 0.5-inch gap supplies in peel mode when backfeed is disabled.
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
Press or until you see
1.
SUPPLY
Backfeed
2.
Press Enter/Pause to set the backfeed option. The current setting is displayed, for
example:
BACKFEED
On
Press or to see the other options. After you display the option you want, press
3.
Enter/Pause. Press Escape/Clear until you see the Main Menu.
Setting Supply Options 4-5