Downloading A Script; Enabling A Script - Monarch 9855 Operator's Handbook Manual

D o w n l o a d i n g a S c r i p t
Follow these instructions to download a script from the MS DOS prompt. Set the
communication parameters using the MODE command. Then, prepare the printer to accept a
script.
From the printer's Script Menu, press  or  until you see
1.
SCRIPTS
Load Script
2. Press Enter/Pause.
Script Load
Ready
Note: Only one script can be loaded in the printer at a time.
When downloading a script, if you receive an error:

Check the available flash memory. See "Checking Available Flash Memory" in Chapter 6
for more information.

Format flash memory. See "Formatting Flash Memory" in Chapter 6 for more information.
After downloading a script, if the script does not appear to be loaded, try formatting flash
memory and download the script again.
E n a b l i n g a S c r i p t
The script must be enabled before you can use it.
To enable or disable a script:
From the Script Menu, press  or  until you see
1.
SCRIPTS
 Enable Script
Press Enter/Pause.
2.
Enable Script?
 Yes
Use  or  to select either "Yes" or "No" and press Enter/Pause. Selecting "Yes" starts
3.
the script. Selecting "No" stops the script. If you select "Yes," when you turn off the
printer and turn it back on, the script automatically starts.
Once the script is enabled, you will see
Print Mode
S Ready
The "S" in the lower left-hand corner of the screen indicates the printer has a script
loaded and enabled (the script is running).


Using Scripts 8-3