About Rfid Supplies - Monarch 9855 Operator's Handbook Manual

A b o u t R F I D S u p p l i e s
RFID supplies are available in a variety of sizes. Printing over the RFID tag (or inlay) causes
printing irregularity. Refer to the
http://www.servisource1.com/prnutil/rfidsetup/
supplies you are using and basic printer configuration information.
Do not modify the Supply Position when using RFID supplies greater than a two-inch
feed length. Doing so may move the RFID tag out of the RF Field's readable and
programmable range. If necessary, you can modify the Print Position; however, make sure you
do not move the tag out of the readable and programmable range.
When using RFID supplies with a one-inch feed length, refer to the
Setup Utility. From the Main Menu, select Setup, Supply, Positioning, then select Print Position
and Supply Position.
The supply options are listed in the table below.
Option Choices
Supply Type Aperture/Die Cut/Black Mark/
Continuous/Tag Edge Aperture/
Center Tag Edge
Ribbon No/Yes/High Energy
Speed 2.5/4.0/6.0/8.0/10.0/Default
Note: The printer pauses while
programming the RFID tag.
Feed Mode Continuous/On-Demand
Backfeed Off/On/Extended
Print Position -450 to 450
Supply Position -300 to 300
Margin Position -99 to 99
Cut Position -300 to 300
Note: The knife is not currently
supported for use with RFID supplies.
Dispense 20 to 200
Position
Backfeed 10 to 200
Distance
Separators No/Yes/Long
Skip Index No/Yes
Knife Control -20 to 20
Error Action Normal
Overstrike/Continue 1x to 5x
Note: If using "overstrike," do not use
Peel Mode.
*
Depends on the supply's feed length. Refer to the
the Supply and Print Position settings.
To exit an option without changing the setting, press Escape/Clear.
4-2 Operator's Handbook
Monarch® RFID Printer Setup Utility
for illustrations to determine which type of RFID
at
Monarch® RFID Printer
Default
Die Cut
Yes
Default
Continuous
Off
0
0
0
0
65
65
No
No
0
Normal
Monarch® RFID Printer Setup Utility
Use for RFID
Die Cut
Any
Any
Any
Conditional*
Conditional*
Conditional*
Any
0 only
Conditional*
Conditional*
Not recommended
Not recommended
0 only
Conditional*
for