Cut Position
This function adjusts where the tag is cut. The printer adjusts the cut position according to the
black marks on the supply. You may need to adjust for aperture supplies. Increase to move
the cut up; decrease to move the cut down.
To change the setting, from the Main Menu, select Setup, Supply, then Positioning. Then,
follow these steps.
Press or until you see
1.
POSITIONING
Cut Pos
Press Enter/Pause. The current setting is displayed, for example:
2.
Enter knife adj
[-300/300]: +0
Press or to change the cut position. Pressing decreases the value (moves the cut
3.
down); increases it (moves the cut up).
4.
Press Enter/Pause when the number you need appears. Press Escape/Clear until you
see the Main Menu.
Dispense Position
This function adjusts the stopping point of the label.
To change the setting, from the Main Menu, select Setup, Supply, then Positioning. Follow
these steps.
Press or until you see
1.
POSITIONING
Dispense Pos
Press Enter/Pause.
2.
DISPENSE POS
[20/200]: +65
Press or to change the dispense position. Pressing decreases the value;
3.
increases it.
Press Enter/Pause when the number you need appears. Press Escape/Clear until you
4.
see the Main menu.
Setting Supply Options 4-9