Table of Contents
Advertisement
Chapter 4.
This chapter describes how to
See your System Administrator for a print job.
n
Printing in On-demand Mode–––––––––––––––––––––––––––––––––
In On-demand mode, the printer prints one label at a time
(when a label is ready to dispense, the LED indicator blinks).
After the printer dispenses the first label, it waits for you to
press [Feed] to print each successive label. You must load
your labels in Peel mode.
The LED indicator is solid green in On-demand mode. Ask the
n
System Administrator to set the mode, if necessary.
To print in On-demand mode:
1. Load supplies for Peel mode. See Chapter 2, "Loading
Make sure the backing paper is pulled tight.
n
2. Send the print job.
3. Press [Feed] to dispense a label.
4. Remove each label after it prints.
Repeat steps 3 and 4 to continue printing the batch.
print in On-demand mode.
remove backing paper.
print in Continuous mode.
clear a print job from the printer's memory.
pause the printer while it prints.
Supplies."
Printing
4-1
Advertisement
Table of Contents
