Verify Write; Retry Encode - Monarch 9855 Operator's Handbook Manual

Verify Write

The printer confirms the read value matches the programmed value after writing (encoding) the
RFID data. The default is disabled.
Note: Enabling verify write decreases throughput.
To change the settings, from the Main Menu, select Setup, then RFID. Then follow these steps.
Press  or  until you see
1.
RFID SETUP
 Verify Write
Press Enter/Pause.
2.
READ AFTER WRITE
Disabled 
Press  or  to change the setting. After you display the option you want, press
3.
Enter/Pause. If you select "Enabled," the printer makes sure the read value matches the
programmed value. If they do not match, an error occurs.
Press Escape/Clear until you see the Main Menu.
4.

Retry Encode

When a supply error occurs, the printer tries to reprint and program (encode) the label. The
printer uses the same EPC data from the label where the supply error occurred and prints it on
the next label. The default is enabled.
When this option is disabled, the printer does not reprint the label and discards the EPC data.
For example, sending a batch of 100 labels with retry encode disabled prints 99 labels (or
less) if a supply error occurs.
Note: This option must be used with incrementing batches.
Enabling retry encode decreases throughput.
Supply errors include: out of supply, out of ribbon, label jam, etc.
To change the settings, from the Main Menu, select Setup, then RFID. Then follow these steps.
Press  or  until you see
1.
RFID SETUP
 Retry Encode
2. Press Enter/Pause.
RETRY ENCODE
Enabled 
Press  or  to change the setting. After you display the option you want, press
3.
Enter/Pause. If you select "Disabled," the printer does not try to reprint and re-program
any label where a supply error occurs. The EPC data is discarded and no error occurs.
Press Escape/Clear until you see the Main Menu.
4.
7-4 Operator's Handbook

