Repeating A Batch; Offline Printing; Special Printing Considerations - Monarch 9855 Operator's Handbook Manual

R e p e a t i n g a B a t c h
Before you start printing a new batch, you can reprint the last batch. The batch can be either
the last one you printed completely or one that you canceled after starting to print.
From the Main Menu, press  or  until you see
1.
MAIN MENU
 Repeat Batch
Press Enter/Pause.
2.
Printing
xxxx of xxxx
The number increments until the entire batch has printed. When it is finished, you will
see
PRINT MODE
Ready
O f f l i n e P r i n t i n g
Offline printing requires the optional keyboard, which must be purchased separately. Refer to
your keyboard's Operating Instructions for more information about offline printing and batch
entry.
S p e c i a l P r i n t i n g C o n s i d e r a t i o n s
Keep in mind the following special printing considerations.
Maximum Printing Method
Print Speed
2.5/4.0/6.0 Thermal Direct
ips (inches Thermal Transfer
per second)
8.0 ips Thermal Direct
Thermal Transfer
10.0 ips Thermal Direct/
Thermal Transfer

The minimum label feed length is 0.75 inches (19 mm) using 8.0 ips or higher.

94x5 emulation is not supported using 300 dpi.

The maximum supply and image length with the optional 300 dpi printhead is 12.0 inches
(305 mm).

You may need to clean the printhead and platen roller more frequently when printing at high
speeds. See Chapter 9, "Care and Maintenance," for more information.

Printhead
Density
203/300 dpi dots
per inch
203/300 dpi
203 dpi only
Knife Peel Mode
Supported Supported
Not Supported Supported
Not Supported Not Supported
Printing 9-5