Backfeed Distance
This is the amount to move the label backwards. The backfeed distance cannot be greater
than the dispense position. If you make the backfeed distance greater than the dispense
position, the dispense position automatically changes to match the backfeed distance.
The backfeed distance should equal the dispense position. An exception is when you are
tearing labels, instead of peeling. Then, the backfeed distance must be 30 dots (0.15 inches)
less than the dispense position to account for improper tearing of butt cut supplies. You will
have a 30-dot non-print zone on your supply, but this prevents exposed adhesive under the
printhead.
To change the setting, from the Main Menu, select Setup, Supply, then Positioning. Follow
these steps.
Press or until you see
1.
POSITIONING
Backfeed Dis
2.
Press Enter/Pause.
BACKFEED DIS
[10/200]: +65
Press or to change the dispense position. Pressing decreases the value;
3.
increases it.
Press Enter/Pause when the number you need appears.
4.
Press Escape/Clear until you see the Main menu.
4-10 Operator's Handbook