R i b b o n
You have to tell the printer if your supplies require a ribbon. To change the setting, from the
Main Menu, select Setup, then Supply. Then, follow these steps.
Press or until you see
1.
SUPPLY
Ribbon
2.
Press Enter/Pause to set the ribbon option. The current setting is displayed, for example:
RIBBON
Yes
Press or to see the other options. After you display the option you want, press
3.
Enter/Pause. Press Escape/Clear until you see the Main Menu.
Note:
If you set the Ribbon option to Yes, install a ribbon before printing.
S p e e d
You can change the print speed for bar codes or graphics. If you select "default" for speed,
formats with serial bar codes automatically print at 2.5 ips and formats with parallel bar codes
print at 6.0 ips.
Note:
The RFID printer pauses while programming the RFID microchip (tag).
To change the setting, from the Main Menu, select Setup, then Supply. Then, follow these
steps.
Press or until you see
1.
SUPPLY
Speed
2.
Press Enter/Pause to set the speed option. The current setting is displayed, for example:
SPEED
Default
Press or to see the other options. After you display the option you want, press
3.
Enter/Pause. Press Escape/Clear until you see the Main Menu.
Note:
For additional high speed printing information, see Chapter 8, "Printing."
4-4 Operator's Handbook