S l a s h e d Z e r o
The slashed zero feature lets you select how you want the zero character printed; either
without a slash, 0 or, with a slash, Ø.
Standard or reduced fonts print the slashed zero character (Ø). Bold and OCR fonts print the
standard zero (0) only. The slashed zero selection will not be in effect until the format is sent
to the printer again. If you change the way zero is printed, you must resend your formats.
To change the setting, from the Main Menu, select Setup, then Defaults. Then, follow these
steps.
Press or until you see
1.
DEFAULTS
Slashed Zero
Press Enter/Pause. The current setting is displayed, for example:
2.
SLASHED ZERO
No
Press or until you see the option you want. Then press Enter/Pause. Press
3.
Escape/Clear until you see the Main menu.
P o w e r - U p M o d e
Power-up mode lets you decide how your printer starts each time you turn it on. If you want
the printer to be ready to start printing when it is turned on, use the Online power-up mode. If
you want the operator to perform some other task first, use the Offline power-up mode.
To change the setting, from the Main Menu, select Setup, then Defaults. Then, follow these
steps.
Press or until you see
1.
DEFAULTS
Powerup Mode
Press Enter/Pause. The current setting is displayed, for example:
2.
POWER UP MODE
Online
Press or until you see the option you want. Then press Enter/Pause. Press
3.
Escape/Clear until you see the Main menu.
6-4 Operator's Handbook