Table of Contents
Advertisement
Intel
®
Server System R1000WT Product Family System Integration and Service Guide
•
Align fan assembly with mounting pins on the chassis base and push down until firmly seated (see letter "A").
•
Repeat for second system fan assembly
•
Connect the fan cables in order to the 10-pin fan connectors on the server board
7.2 Replacing a System Fan
System fans used in the Intel Server System R1000WT product family are NOT hot-swappable.
•
Power off the system and remove the system top cover (see section 2.2.1)
•
Disconnect the cable of the target fan (Note: disconnecting the cables from the remaining fans in the fan assembly
is not required)
•
Lift the system fan assembly from the chassis
•
From the bottom of the fan assembly, push out the target fan (see letter "A").
•
Locate the replacement fan (Intel product Code – FR1UFAN10PW).
•
Install replacement fan into fan assembly, ensuring all rubber guides are in place and the cable is located on the
side closest to the server board. (see letter "B").
•
Align the fan assembly mounting holes with pins on the chassis base and push down until firmly seated. Ensure
that no fan cables are trapped beneath the fan assembly.
•
Attach the fan cable to the fan connector on the server board.
•
Ensure that all fan cables are securely connected
Rev 2.2
Figure 93. Remove a failed system fan
71
Advertisement
Table of Contents
