Link Timeout - Datalogic Gryphon I GBT4400 Product Reference Manual

Enter/Exit Programming Mode

Link Timeout

This feature specifies the wait time in one-second ticks for response from the remote. The
selectable timeout range is 01 to 40 (01-0x28) seconds in one second increments.
See page 252
$CBTLT
Set Link Timeout
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.
DEFAULT
240
for more information on setting this feature.
02 Link Timeout value is 2 seconds
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
~
CANCEL
Gryphon™ I GD44XX/GBT4400
Appendix D, Keypad