Enter/Exit Programming Mode
Micro PDF417 Length Control
This feature specifies either variable length decoding or fixed length decoding for this
symbology.
Variable Length:
Fixed Length:
DEFAULT
$CMILC01(CR)
Micro PDF417 Length Control = Fixed Length
Micro PDF417 Set Length 1
Specifies one of the bar code lengths for
minimum label length if in
Mode. Length includes the bar code's data characters only. Characters can be set from 0001 to
0366 characters (pad with zeroes) in increments of 01. Any value greater than 0366 will be
considered to be 0366.
See
page 259
$CMIL1
Select Micro PDF417 Length 1 Setting
Make a mistake? Scan the CANCEL bar code to abort
and not save the entry string. You can then start again at
the beginning.
216
For variable length decoding, a minimum and maximum length may be set.
For fixed length decoding, two different lengths may be set.
Variable Length
for detailed instructions on setting this feature.
0001 = Length 1 is 1 Character
DEFAULT
$CMILC00(CR)
Micro PDF417 Length Control = Variable Length
Micro PDF417 Length
Control. Length 1 is the
Mode, or the first fixed length if in Fixed Length
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE barcode above, then the barcode at
left followed by the digits from the Alphanumeric char-
Appendix D, Keypad
acters in
desired character(s). End by scanning the ENTER/EXIT
barcode again.
~
CANCEL
Gryphon™ I GD44XX/GBT4400
Micro PDF417
representing your