Wedge Quiet Interval; Intercode Delay - Datalogic Gryphon I GBT4400 Product Reference Manual

Wedge Quiet Interval

Specifies amount of time to look for keyboard activity before scanner breaks keyboard
connection in order to transmit data to host. The selectable range for this setting is 00 to 990
milliseconds (00-0x63 by 01) in increments of ten milliseconds. See
for detailed information and examples for setting this feature.
$CKBQI
Set Wedge Quiet Interval
Make a mistake? Scan the CANCEL bar code to
abort and not save the entry string. You can then
start again at the beginning.

Intercode Delay

Specifies the delay between labels transmitted to the host for this interface. The selectable range
for this feature is from 0 to 99 seconds.
See page 258
$CKBID
Set Intercode Delay
Make a mistake? Scan the CANCEL barcode to
abort and not save the entry string. You can then
start again at the beginning.
Product Reference Guide
DEFAULT
in "References" for detailed information and examples for setting this feature.
Enter/Exit Programming Mode
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
~
CANCEL
0A = Quiet Interval is
100 milliseconds
To configure this feature, scan the ENTER/EXIT
PROGRAMMING MODE barcode above, then the
barcode at left followed by the digits from the
Alphanumeric characters in
representing your desired character(s). End by
scanning the ENTER/EXIT barcode again.
~
CANCEL
page 256 in "References"
Appendix D, Keypad
Appendix D, Keypad
57