Linking The Reader; Link Datalogic Devices To Base; Link Scanner As Serial Device To A Bluetooth Host - Datalogic QuickScan QBT2500 Quick Reference Manual

LINKING THE READER

Link Datalogic Devices to Base

Before configuring the interface, it is necessary to link the
handheld with the base.
To link the handheld and the base, simply put it into the
base. If the reader was previously linked to another base,
you must first scan the
to the new base.

Link Scanner as Serial Device to a Bluetooth Host

Use this procedure to let the scanner communicate with a
Bluetooth host using the Bluetooth Serial Port Profile
(SPP).
1. If using a Bluetooth adapter on the host device, install
any driver provided with the adapter.
2. Scan the
make the scanner visible to the host device.
3. Use the Bluetooth manager of the host device to "Dis-
cover new devices" and select "QBT2500...".
If you receive an error message, it may be necessary
to change the security settings on either the host
device or the scanner.
4. Use an RS-232 terminal program to see incoming data
on the port designated by the Bluetooth manager of
the host device.
Unlink
Link to Host in SPP mode
Link to Host in SPP Mode
bar code before re-linking it
Unlink
QUICK REFERENCE GUIDE
Linking the Reader
label below to
13