Disable Character; Enable Character - Datalogic Gryphon I GBT4400 Product Reference Manual

Disable Character

Specifies the value of the RS-232 host command used to disable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
See page 254
$CR2DC
Select Disable Character Setting

Enable Character

Specifies the value of the RS-232 host command used to enable the reader.
ASCII characters or any hex value from 0 to 0xFF can be selected.
See page 255
$CR2EC
Select Enable Character Setting
Product Reference Guide
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
as 7 Data Bits.
for more information on setting this feature.
0x44 = Disable Character is 'D'
DEFAULT
Setting to previously defined characters such as XON, XOFF, or host
commands conflicts with normal operation of these characters. 8-
bit data is not recognized when the option
as 7 Data Bits.
in "References" for more information on setting this feature.
DEFAULT
0x45 = Enable Character is 'E'
Enter/Exit Programming Mode
Data Bits
has been set
Data Bits
has been set
51